GE JCB560 Manuel D'utilisation page 34

Cleaning the glass cooktop.
Glass surfac
Sugary spillovers (such as jellies ,
fudge,candy, syrups) or melted
plastics can cause pitting of
thesurface of yourcooktop
(not covered by thewarranty)
unless thespill is removed while
still hot. Special care shouldbe taken
when removing hot substances.
Be sure touse a new, sharp razor
scraper.
Donotuse a dull or nicked blade.
34
(on radiant models)
Metal Marks and Scratches
Be careful not to slide pots and pans
across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using
the Ceramic Cooktop Cleaner with
the Cleaning Pad for Ceramic Cooktops.
Cooktop Seal
To clean the cooktop seal around
the edges of the glass, lay a wet cloth
on it for a few minutes, then wipe clean
with nonabrasive cleaners.
potential for permanent damage.
Damage from Sugary Spills and Melted Plastic
Turn off all surface units. Remove
hot pans.
Wearing an oven mitt:
a. Use a single-edge razor blade scraper
to move the spill to a cool area on
the cooktop.
b. Remove the spill with paper towels.
Any remaining spillover should be left
until the surface of the cooktop has
cooled.
To Order Parts
To order CERAMA BRYTE
Cooktop Cleaner and the cooktop
scraper, please call our toll-free number:
National Parts Centre
800.661.1616
CERAMA BRYTE Ceramic
®
Cooktop Cleaner . . . . . . . .CERAMABRYTE
CERAMA BRYTE Ceramic
®
Cooktop Scraper . . . . . . . . . . . . . . . . TE05-503
Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45898
(Kit includes cream and cooktop scraper)
WARNING:
bottom of pans for roughness that would
scratch the cooktop.
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced. In this case,
service will be necessary.
Ceramic CERAMA BRYTE
®
Ceramic Cooktops . . . . . . . . . .28001
If pots with a thin overlay of aluminum
or copper are allowed to boil dry, the
overlay may leave black discoloration
on the cooktop.
This should be removed immediately
before heating again or the discoloration
may be permanent.
Carefully check the
Don't use the surface units again until
all of the residue has been completely
removed.
Cleaning Pads for
®