GE JCB560 Manuel D'utilisation page 16

Using the clock and timer.
C
LOCK
H
ORLOGE
Make sure the clock is set to the
correct time of day.
T
IMER
M
INUTERIE
The Timer is a minute timer only.
The Timer does not control oven
operations. The maximum setting on
the Timer is 9 hoursand 59 minutes.
16
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Touch the TIMER pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake, touch the TIMER pad and
begin again.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by
touching the TIMER pad, then touch
the number pads until the time you
want appears in the display.
To Cancel theTimer
Touch the TIMER pad twice.
Touch the CLOCK pad.
Touch the numberpads.
Touch the START pad.
When the Timer reaches :00 , the
control will beep 3 times followed by
one beep every 6 seconds until the
TIMER pad is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time
by touching the TIMER pad and then
touching the number pads to enter the
new time you want.