Olympia A 245 Combo Mode D'emploi page 25

Cleaning the Transport Rollers
Adhesive residues and other deposits on the rollers can impair the lamination result. Remove
these at regular intervals and whenever the lamination result is not as good as expected.
1
Set the On/Off switch
Ä The transport rollers start to rotate.
Ä The POWER LED
2
Wait 2 - 3 minutes until the laminator has warmed up.
Ä The READY LED
ing temperature. The POWER LED
3
When the device has reached operating temperature, insert a sheet of A4 paper in the
infeed of the device until the transport rollers clamp it.
9
Ä The paper is transported through the device and is discharged at the output
residues are deposited on the paper.
Caution! Risk of burns through hot residual laminated material. After cleaning, very hot
residual laminated material is stuck to the ejected paper. Only remove the paper
discharged by holding it at the cooled end.
4
Repeat this process several times to clean the transport rollers.
Ä The transport rollers of the laminator have been cleaned.
Technical Data
Subject to change without prior notice.
Model number
Power supply
Current strength
Power consumption, max.
Pouch thickness
Maximum document thickness
Heat-up time
Laminating speed
Maximum document thickness
Max. cutting capacity
Max. cutting length
Weight
Dimensions (W × D × H)
Colour
to HOT (II).
7
lights up RED.
5
turns GREEN, when the device has reached the required operat-
6
Olympia A 245 Combo, Art. No. 3170
230 V ‒ 240 V, 50 Hz
2.0 A
450 W
80 ‒ 125 micron
Up to A4, 210
Approx. 2 ‒ 3 minutes
Approx. 300 mm/min
0.6 mm
3 sheets
310 mm
1 kg
×
363 140
black
lights up RED.
5
×
297 mm (8 1/4"
×
79 mm
g
12
×
11 3/4")
. All the
25