Mitsubishi Electric CITY MULTI Smart ME Controller Manuel D'installation page 16

2 Service Menu
[HOME screen]
A password is required to access the Menu
.
screen
• The initial Service password is "9999." The initial User password is "0000." Change the password
as necessary to prevent unauthorized access.
• Make sure the password is available to the maintenance and other necessary personnel.
• The password can be changed to any four-digit number. On the [Login page], enter the old
password, touch the [Change] button, and then enter a new password.
Service menu items
Item Detail Description
(1) Setup (a) Group Make the group setting for the
setting
indoor units, and an AHC
(b) Interlocked Enters the interlock settings
LOSSNAY between indoor and LOSSNAY
units
(c) Search Use to search and display the
connection units that are connected to a
information specified unit.
(d) Cool/Heat Use to show or hide the
display operation mode signs (Cool/
Heat) on the HOME screen
while the units are operated in
the Auto mode or the Setback
mode.
(e) Override Use to enable or disable the
control Override function and to set the
override time when the function
is enabled.
* Use to enable or disable the
(f) Temperature Use to offset the reading on the
sensor offset built-in temperature sensor. *1
(g) Humidity Use to offset the reading on the
sensor offset built-in humidity sensor.
(h) Auto mode Use to select the number of set
Single/Dual points (single/dual) to be used
in the Auto mode.*2
[MENU(User) screen]
Service screen or some settings under the Menu
( )
function that restores the
original set temperature after
the preset override time has
elapsed (when the set
temperature was changed
while the units were operated
in the Setback mode).
– 16 –
[MENU(Service) screen]
Setting Default
Refer to section 1 –
"Initial Settings" (2)
"Setup screen".
Select between Show/ Auto: Show
Hide. Setback: Show
• Select between Override: Enable
Enable and Disable. Override time: 2:00
• Set the override time in
5-minute increments
(max. 9 hours and 50
minutes ).
Set the offset value. Offset: 0ºF (0.0ºC)
(-5ºC~+5ºC)
(-10ºF~+10ºF)
Set the offset value. Offset: 0%
(-10%~+10%)
Select between single –
and dual. (Varies depending on the
* Not available if the air connected indoor unit
conditioning units do model.)
not feature the Auto
function.
User
( )