Husqvarna 440e TrioBrake Manuel D'utilisation page 33

Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for chain saws 440e TrioBrake and 445e TrioBrake. The
combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and
Z62.3-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Bar and chain combinations
Model:
Length, inch
13
440e
15
TrioBrake,
445e
16
TrioBrake
18
20
13
15
445e
TrioBrake
16
18
20
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
0,050"/1,3 mm
0,058"/1,5 mm
Saw chain filing and file gauges
440e TrioBrake
445e TrioBrake
445e TrioBrake
1153159-32 Rev.1 2009-12-29
TECHNICAL DATA
Bar
Pitch, inch
0,325
0,325
0,325
0,325
0,325
0,325
0,325
0,325
0,325
0,325
H30 H22 H23
- H25 H21
Max. nose
Gauge, mm
radius
10T
10T
1,3 10T
10T
10T
10T
10T
1,5 10T
10T
12T
Chain
Length, drive
Type
links (no.)
56
64
Husqvarna H30 66
72
78
56
64
Husqvarna H25 66
72
78
English – 33