Publicité
Les langues disponibles
Les langues disponibles
3. Clean the appliance daily. Use a damp cloth and a mild cleaning agent.
4. Dry the appliance. Use paper towels or a dry tea towel.
5. In case of heavy dirt, clean the appliance with a special cleaning agent suitable for an induction appliance.
6. In case of spillovers on the controls, the appliance may beep and turn itself off. Soak up the spill and dry the area
before turning the appliance back on.
7
Cleaning and maintenance of the cooker hood
CLEANING THE GRILLE AND THE GREASE FILTER
The grease filter filters the grease from the cooking vapours. To keep it in good working order, you must clean the
grease filter regularly.
•
Never operate the appliance without the grease filter in place.
•
Clean the grease filter regularly. It is recommended to clean the grease filter every 7 days.
•
Do not work with open fire close to the appliance (e.g. flambé).
Warning:
Risk of fire.
Fatty disposits in the grease filter may catch fire.
(Figure 4)
1. Remove the grille.
2. Take out the grease filter.
Note:
Grease can accumulate on the bottom of the grease filter. Make sure to hold the grease filter level to
prevent accumulated grease from dripping out.
3. Clean the grille and the grease filter by soaking them in hot soapy water.
a. Use a brush to clean the grille and the grease filter.
b. Do not use aggressive, acidic or alkaline cleaning product.
c. If necessary, use a special grease solvent.
4. Rinse the grille and the grease filter thoroughly.
5. Allow the grease filter to drain.
6. Dry the components. Use a dry tea towel.
7. If necessary, clean the grease filter in a dishwasher at a maximum temperature of 70°C.
Note:
The grease filter can change color after cleaning. This is normal.
CLEANING THE CAVITY AND DRAINAGE
In case of spills, it might be necessary to clean and drain the cavity. Remove the grille and the grease filter before
cleaning the cavity.
Warning:
Make sure the appliance is cooled down, and the residual heat indicator has gone out before cleaning
the cavity.
(Figure 5)
1. Put a container below one of the rubber plugs at the bottom of the appliance.
2. Pull out the rubber plug with one hand and hold the container with the other hand to drain the liquid.
3. Ensure the drainage hole is not blocked and put the plug back into place. Press the plug in tightly.
4. Repeat steps 1 to 3 for the second rubber plug.
5. Remove any objects that might have fallen in from above, and wipe out the inside of the appliance with soapy
water and a dish cloth.
6. Dry the cavity and re-insert the grease filter and the grille.
(Figure 6)
English
•
37
Publicité
