Troubleshooting Guide - AVG PRYMO ABC160S2 Manuel D'utilisation

6. TROUBLESHOOTING GUIDE

You can solve many common appliance problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
Problem
Appliance does not operate.
Appliance is not cold enough.
Turns on and off frequently.
The light does not work.
Vibrations.
The appliance seems to make
too much noise.
The door will not close
properly.
Condensation on the door
If after consulting the troubleshooting guide your problem is still not resolved, please contact
the retailer where your purchase was made.
Possible cause
Not plugged in.
The appliance is turned off.
Tripped circuit breaker or blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The room temperature is higher than normal.
A large amount of contents has been added to the appliance.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Not plugged in.
Tripped circuit breaker or blown fuse.
The bulb has burned out.
The light button is OFF. Or
on.
Check to be sure the appliance is level.
The appliance is not level.
The appliance is not level.
The door was reversed and not properly re‐installed.
The gasket is dirty.
The shelves are out of position.
In extreme weather temperature, it's normal that
condensation appears on the door
The unit is installed directly facing the sun
The internal temperature is too low
The unit is installed in a none air conditioned room
Energy conservation button is
24