Télécharger Imprimer la page

Maico HDR 12 Instructions De Montage Et Mode D'emploi page 15

Diagonaux pour installation en gaine ronde

Publicité

Les langues disponibles

Les langues disponibles

Depending on size and temperature
i
conditions, it may take up to 30 mi-
nutes to cool down. Only then can
the unit be switched back on.
EC units: The internal control electronics
prevent the fan from overheating/overload
(thermal fuse in motor winding).
6. Operation: Switching on/off
The fan is switched on and off with a switch,
for example, with a suitable 3-step switch.
For accessories  Internet (www.maico-
ventilatoren.com). Ensure sufficient supply air
during operation.
7. Technical data
For technical data,  the rating plate [T].
For dimensions  Figure B.
For characteristic curves  Internet:
www.maico-ventilatoren.com.
Rated voltage
Power frequency
AC motor
EC motor
Degree of protection
Air volume
free outlet or
free inlet
Temperature class
Maximum air flow
temperature
Weight
230 V
50 Hz
50/60 Hz
IP 44
326 to 684 m³/h,
depending on unit
type
B
50 °C
AC units 2.5 kg
EC units 1.7 kg
5. Product information │ UK
8. Transport, storage
8.1 Transport
WARNING
Danger if impermissible means of
transport or lifting gear are used.
Note weight and centre of gravity (centre).
Do not stand under a suspended load.
NOTICE
Risk of damage if means of transport are
incorrectly attached. Do not place load on
sensitive components, such as the impeller.
8.2 Storage
● Only store fan horizontally in a suitable,
dry room: Ambient temperature -10 to
+60 °C.
● Before installing it, check that the diagonal
fan is working properly.
● Maico accepts no liability for corrosion
damage caused by improper storage,
e.g. storage in a damp room.
9. Installation preparations
Important mounting
i
information
Fan operation only permitted with:
● permanent installation in flexible ducts with
folded spiral-seams ducts Ø 100 to Ø 160 mm
to suit the unit type (nominal size).
● permanent electrical supply cable.
● installation on a wall, ceiling or bracket of
sufficient load-bearing capacity.
● correct installation position with terminal
box facing upwards or sideways. The
terminal box may not face downwards.
15

Publicité

loading