Service Position For The Cutting Unit - Husqvarna R 120S Manuel D'utilisation

Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
Check the air duct, located on the inside of the engine cover,
ensure it is clean and does not rub against the cooling air
intake.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
WARNING! The cooling air intake rotates
!
when the engine is running. Do not allow
hands, clothing, jewelry or any other items
to come in contact with the engine fan while
the engine is running. Mind your fingers.

Service position for the cutting unit

The cutting deck can be removed in order to facilitate cleaning
and servicing.
To remove the cutting deck proceed as follows:
1 Position the machine on flat ground.
2 Apply and lock the parking brake.
3 Check that the lever for setting the cutting height is in the
S position.
4 Put the lifting lever in the mowing position.
Maintenance
5 Release the clip on the right side of the mower deck and
lift the cover off the mower deck.
6 Loosen the spring on the drive belt's belt idler by
loosening the handle.
7 Lift of the drive belt.
8 Grip the top tubular construction of the unit and pull out
the unit until it stops.
9 Remove the pin in the equipment frame.
10 Loosen the stay from the cutting deck.
11 Pull out the cutting unit.
12 Lift off the deck and lean it against the machine or a wall.
– 23
English