Télécharger Imprimer la page

Nemox Gelatissimo exclusive I-GREEN Instructions D'utilisation page 22

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
STORAGE TIME
I c e c r e a m b a s e d o n u n c o o k e d
ingredients ± 1 week
Sorbets 1-2 weeks
Ice cream based on cooked ingredients
± 2 weeks
HELPFUL TIPS
Some recipes involve cooking. Prepare
them at least the day before to make
sure they cool completely and expand.
Never pour ingredients that exceed
25°C into the machine.
Pour in the ingredients up to half the
volume of the bowl. The mixture
increases in volume during preparation.
Alcoholic ingredients slow down the
cooling process. The alcohol should
therefore be added during the last few
minutes of preparation.
The flavour of sorbets primarily
d e p e n d s o n t h e r i p e n e s s a n d
sweetness of the fruit and juice used.
Remember that cold reduces the
perception of sweetness.
Fruit used in recipes must always be
washed and dried before use. Even
when not specified, the fruit must always
be peeled, pitted, etc.
For the total amount of a recipe to be
reduced, the amount of every ingredient
must be reduced proportionally.
The preparation time varies according
to the quantity and temperature of the
ingredients and the environment and
the type of preparation, if ice cream or
sorbet.
22
E E n n g g l l i i s s h h
WHAT MAY NOT WORK
Under normal conditions, ice cream
preparation takes no more than 30-40
minutes.
If the ice cream has still not formed after
40-50 minutes, check all the following
points before requesting assistance
from an authorised service centre.
The ingredients must be poured into the
ice cream maker at room temperature or
better, at refrigerator temperature. It is
impossible to make ice cream if the
ingredients are hot.
The bowl must not be filled to more than
half its capacity. If there are too many
ingredients, the time required for the ice
cream to form increases significantly
and the result may not be satisfactory.
Due to the presence of a safety device
on the compressor, the cooling device
stops running if a power cut should
occur or if the machine is switched off
and on again for any reason.
In these cases, let the appliance rest for
10 minutes before turning it back on. If
the 10 minute pause is not respected,
operation will not resume even though
the cooling button is in the ON position.
TROUBLESHOOTING
PROBLEM: The machine does not cool
down:
POSSIBLE CAUSES:
Check that the power plug is properly
plugged in and that the electricity
reaches the appliance. Check that the
(N) and (L) buttons are ON.

Publicité

loading