Husqvarna EPOS Reference Station Manuel D'utilisation page 57

36.1 Introduction - maintenance
For better operation and lifetime of the product, make
sure to clean the product regularly and replace worn
parts.
36.2 Maintenance schedule
The maintenance schedule shows how to do
servicing and maintenance on the product. Follow the
maintenance schedule for a better operation and to
increase the lifetime of the product.
To prepare
Clean the product on page 57 .
Clean the product. Refer to
Examine the product for damage and wear.
Do an update of the firmware.
Do a check of the servicing messages for recommended upgrades.
Servicing
Do a check of the tightening torque of the screws. Refer to
57 .
Replace the airflow filter.
Open the product and replace all sealing strips.
36.3 Clean the product
WARNING:
from the power supply before any
maintenance or cleaning.
36.4 Tightening torques
Screw
Upper to lower chassis
Reference station to arm
Arm to post
Arm, support bracket and post bracket
1512 - 005 -
36 Maintenance
Disconnect the product
Tool
Torx 20
Torx 20
Hex key, 4 mm
Hex key, 4 mm
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Speak to your approved servicing dealer.
Tightening torques on page
CAUTION:
washer to clean the product. Do not use
solvents for cleaning.
If necessary, clean the product with a moist cloth.
Tightening torque (Nm)
1.8
1.8
5-6
5-6
Every year Every third
year
X
X
O
O
X
O
O
Do not use a high-pressure
Maintenance - 57