Husqvarna EPOS Reference Station Manuel D'utilisation page 56

4. Put the cable of the reference station through the
slot in the arm and install the reference station on
the arm.
5. Attach the connector to the clips on the arm.
56 - Installation
6. Tighten the screw (Torx 20) on the arm of the
reference station.
T20
7. Connect the low-voltage cable to the reference
station and the power supply.
8. Attach the low-voltage cable to the wall from the
reference station to the power supply with cable
ties.
CAUTION:
cable is not attached tightly with cable
ties it can be damaged in hard wind.
9. Put the power supply 30-200 cm / 1-6.5 ft. above
the ground. Refer to To examine where to put the
power supply on page 53 .
10. Connect the power supply cable to a 100-240V
power outlet.
11. Wait until the LED status indicator is solid green.
First the LED status indicator flashes green for
some minutes. Refer to
reference station on page 58 .
If the low-voltage
LED indicator lamp on the
1512 - 005 -