Husqvarna DE 110i H Manuel D'utilisation page 18

Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
WARNING:
correctly can decrease the product life
cycle and increase the risk of accidents.
Maintenance
Do the filter purge procedure. Refer to
To remove dust particles from the prefil-
ter during operation on page 15 .
Look for signs of wear or damage of the
dust release rubber cone.
Look for signs of wear, damage or loose
connections of the controls before the
unit is connected.
Do a check of the hose and the hose
connectors.
Look for signs of wear or damage of the
plastic parts.
Do a check of the lifting eyes.
Make sure that the Longopac is correct
and that it is correctly attached. Refer to
To install a new Longopac bag cassette
on page 16 .
Do a check of the filter purge function.
Do a check of the wheels. Look for
damage and bad connections.
Do a check of the filter seals
Do the filter purge procedure. If the
suction continues to be not sufficient,
clean the prefilter with water. Refer to
To clean the prefilter with water on page
20 .
Replace the cleaned prefilter if the suc-
tion continues to be not sufficient. Refer
To replace the prefilter on page 21 .
to
18
Maintenance
Read and understand the
Remove the battery before
Failure to do maintenance
Before
each use
X
X
X
X
X
X
All servicing and/or repair work must also
be done by a professional. Turn to your
servicing dealer for more information.
WARNING:
obey all local regulations to dispose the
dangerous dust correctly, before and during
maintenance.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Daily Weekly suction is
X
X
X
X
Make sure that you
When Each 12
months or months or
low 600 h
X
X
1618 - 006 - 01.06.2023
Each 24
2000 h
X