Husqvarna DE 110i H Manuel D'utilisation page 17

7. Close the bottom of the Longopac with a cable tie.
To discard a full Longopac bag and
prepare a new Longopac bag
WARNING:
caution, a full Longopac bag can be heavy.
Make sure that the cable ties are closed
correctly before you lift the Longopac bag.
1. Pull out the Longopac bag (A) and attach a cable tie
(B) to close the new Longopac bag.
B
1618 - 006 - 01.06.2023
Lift the Longopac bag with
A
2. Shake down the dust in the used Longopac bag.
3. Attach a cable tie 10 cm/3.9 in. below the first cable
tie to close the used Longopac bag. Cut off the
Longopac bag between the cable ties.
4. If the remaining part of the Longopac bag cassette
is too small to prepare a new Longopac bag, install
a new Longopac bag cassette. Refer to
new Longopac bag cassette on page 16 .
5. Obey local regulations for disposal of the full
Longopac bag.
To do after completed work
1. Do the filter purge procedure. Refer to
dust particles from the prefilter during operation on
page 15 .
2. Stop the product, refer to
15 .
3. Discard the Longopac bag. Refer to
Longopac bag and prepare a new Longopac bag on
page 17 .
4. Clean the product. Refer to
page 19 .
5. Prepare the product for transportation. Refer to
move the product long distances on page 25 .
To install a
To remove
To start and stop on page
To discard a full
To clean the product on
To
17