Publicité
Les langues disponibles
Les langues disponibles
5. Push the battery release buttons (A) and remove
the battery (B) from the battery holder to prevent
accidental start.
A
To start and stop
Note:
The suction is not at full capacity directly at
start, the suction operates fully after 5 seconds.
1. Install the battery. Refer to
battery on page 14 .
2. Push the On/Off button to start the product.
3. Select correct hose diameter. Refer to
hose nozzle diameter on page 13 .
4. To stop the product, push and hold the On/Off button
until the green LED light goes off.
5. Remove the battery from the battery holder. Refer to
To install and remove the battery on page 14 .
1618 - 006 - 01.06.2023
B
A
To install and remove the
To select the
Hour meter
The hour meter shows the total operation time of the
product in hours.
To remove dust particles from the
prefilter during operation
The filter purge procedure cleans the prefilter from
unwanted material. Do the procedure in these situations:
•
Before a work stop or at the end of each work day.
If the product is off for a while, it gives the dust
more time to fall down. This makes the filter purge
procedure more powerful.
•
When the suction is not sufficient.
•
Before installation of a new Longopac bag.
•
When the prefilter clogged alarm goes off.
1. Stop the product and let the dust fall down into the
Longopac bag.
2. Start the product. Refer to
15 .
3. Close the air flow that moves through the air intake
with the air intake plug or the intake valve to make
vacuum.
4. Wait 5 seconds until vacuum is made, then push the
filter purge button. Do this step 3 to 5 times. It is
important to let the product make vacuum between
each button push.
X 3-5
If the suction is not sufficient after this procedure, it is
necessary to clean the prefilter with water. Refer to
clean the prefilter with water on page 20 .
To start and stop on page
To
15
Publicité
