Publicité
Les langues disponibles
Les langues disponibles
GB
13. Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
1)
Unplug the power plug. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2)
Divide the spray gun. Press the hook (Fig. 3 b "click") slightly downwards.
front part and gun rear part against each other and take them apart.
3)
Unscrew the container. Empty any remaining coating material back into the material
tin.
4)
Preclean the container and suction tube with a brush. Clean the ventilating bore
(Fig. 10, C).
5)
Pour solvent or water into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
6)
Assemble the gun again (Fig. 3).
7)
Insert the power plug, turn on the machine and spray the solvent or water into a
container or a cloth.
8)
Repeat the above procedure until the solvent or water emerging from the nozzle is
clear.
9)
Turn off the machine and remove the plug.
10)
Screw of the container and empty it. Pull out the suction tube with container seal.
CAUTION!
Never clean seals, diaphragm and nozzle or air holes of the spray gun with metal
objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
11)
Pull the ventilating hose (Fig. 10 A, 13) at the top from the gun body. Screw off the
valve cover (14). Remove the diaphragm (15). Clean all the parts carefully.
WARNING! Never hold the spray gun rear part under water or immerse it
into liquids. Clean the housing only with a moistened cloth.
12)
Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
13)
Unscrew the union nut (Fig. 10, 1) and remove the air cap (2) and nozzle (3). Clean the
air cap, nozzle seal (4) and nozzle with a brush and solvent or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig. 10 A, 15). Place the
diaphragm with the pin facing upwards on the bottom section of the valve. Also see the
marking on the gun body. Place on the valve cover and screw it closed. Place the ventilating
hose on the valve cover and on the nipple at the gun body.
22
W 550
Turn the gun
Publicité
