SCHOLTES FN 54 T XA Mode D'emploi page 25

Care and maintenance
Switching the appliance off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully ( see diagram ).
2. Lift up and turn the small levers located on the
two hinges ( see diagram ).
3. (with glass panel fitted to
the inside of the door) Grip the
door on the two outer sides
and close it approximately
half way. Unlock the door by
F
pressing on the clamps F F F F F ,
then pull the door towards
you, lifting it out of its slot
( see diagram ).
To replace the door, reverse this sequence.
F
Inspecting the seals
Check the door seals around the oven at regular
intervals. If the seals are damaged, please contact
your nearest Service Centre ( see Assistance ). We
recommend that the oven is not used until the seals
have been replaced.
Replacing the light bulb
Oven
compartment
Lamp
Glass cover
3. Replace the glass cover ( see diagram ).
! Do not touch the light bulb directly with your
hands.
Assembling the sliding rack kit
To assemble the sliding racks:
1. Remove the two frames, lifting them away from
the spacers A ( see figure ).
2. Choose which shelf to use with the sliding rack.
Paying attention to the direction in which the sliding
rack is to be extracted, position joint B and then
joint C on the frame.
A
3. Secure the two frames with
the guide rails using the holes
provided on the oven walls
( see diagram ). The holes for
the left frame are situated at
D
the top, while the holes for the
right frame are at the bottom.
4. Finally, fit the frames on the spacers A.
! Do not place the sliding racks in position 5.
1. Remove the
glass cover of the
lamp-holder.
2. Remove the
light bulb and
replace it with a
similar one:
halogen lamp
voltage 230 V,
wattage 25 W,
cap G 9.
Left
Right guide
guide rail
rail
B
C
GB
25