Worx WX106 Manuel D'instructions page 8

workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel
may bind, walk up or kickback if the power tool is
restarted in the workpiece.
g) Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag
under their own weight. Supports must be
placed under the workpiece near the line of cut
and near the edge of the workpiece on both sides
of the wheel.
h) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
Safety Warnings Specific for Wire Brushing
Operations:
a) Be aware that wire bristles are thrown by
the brush even during ordinary operation.
Do not overstress the wires by applying
excessive load to the brush. The wire bristles
can easily penetrate light clothing and/or skin.
b) Allow brushes to run at operating speed
for at least one minute before using them.
During this time no one is to stand in front
or in line with the brush. Loose bristles or
wires will be discharged during the run-in time.
c) Direct the discharge of the spinning wire
brush away from you. Small particles and
tiny wire fragments may be discharged at high
8
velocity during the use of these brushes and may
become imbedded in your skin.
SAFETY WARNINGS FOR
BATTERY CELLS INSIDE
THE TOOL
a) Do not dismantle, open or shred cells.
b) Do not short-circuit charging terminal.
Do not store power tool haphazardly in a
box or drawer where charging terminal
may short-circuit each other or be short-
circuited by conductive materials. When
power tool is not in use, keep it away from other
metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects, that can
make a connection from one charging terminal to
another.
c) Do not expose power tool to heat or fire.
Avoid storage in direct sunlight.
d) Do not subject power tool to mechanical
shock.
e) In the event of battery leaking, do not
allow the liquid to come into contact
with the skin or eyes. If contact has been
made, wash the affected area with copious
amounts of water and seek medical advice.
f) Keep power tool clean and dry.
Rotary Tool
g) Wipe the charging terminals with a clean
dry cloth if they become dirty.
h) Power tool needs to be charged before use.
Always refer to this instruction and use the
correct charging procedure.
i) Do not maintain power tool on charge when
not in use.
j) After extended periods of storage, it may
be necessary to charge and discharge
the power tool several times to obtain
maximum performance.
k) Recharge only with the charger specified
by Worx. Do not use any charger other than
that specifically provided for use with the
equipment.
l) Keep power tool out of the reach of
children.
m) Retain the original product literature for
future reference.
n) Dispose of properly.
o) Do not mix cells of different manufacture,
capacity, size or type within a device.
p) Do not use any cell which is not designed
for use with the equipment.
q) Keep the battery away from microwaves
and high pressure.
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Batteries may enter water cycle
if disposed improperly, which
can be hazardous for ecosystem.
Do not dispose of waste batter-
ies as unsorted municipal waste.
EN