Worx WX106 Manuel D'instructions page 10

Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Grinding head
Rubber wheel
Big sand ring
Cutting blade
Cutting blade rod core
Big felt
Small felt
Felt rod core
Wire brush
Polishing paste
10
Bit
Milling cutter
Spanner
Diamond grinding needle
USB charging cable
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
USAGE
The electric tool is designed to be used as grinding
machine, sanding machine, wire brush, polishing
machine, carving or cutting tool. The combined tool
is very suitable for processing wood, plastic, stone,
aluminum shell, brass and steel.
Rotary Tool
BEFORE OPERATION
A) Long press the speed adjustment button "-"(4B)
to display the battery level.
B) The battery must be fully charged before
using for the first time.
C) Charge the device (use charger)
Plug the charger plug into the power socket and
wait for a while. The battery indicator (6) will light
up and display the charging status.
LED status
WX106
The battery indicator is flashing
Battery charging
1
The power indicator stops flashing
Battery charging complete
1
When the battery is fully charged, unplug the
charger from the socket, and then pull the small
4
plug from the device.
The charger must use DC 5V 500mA to
2
1000mA switching power supply
1
charger.
ASSEMBLY
2
Mounting accessories
2
Make sure that the machine is
turned off before installing
1
accessories.
1
Note: replace the accessories by
inserting them into the collet (or
1
chuck) as far as possible to minimize
exhaustion and
1
imbalance.
Accessory assembly
3
Press and hold the spindle lock (3).
1
The collet chuck (1) can be undone
with chuck wrench (7). Put the
1
accessories in place.
Hold down the spindle lock when
1
fixing the collet chuck with chuck
wrench.
Do not press the spindle lock
button when the motor is
running.
OPERATION
Press the on / off button (5) to turn on
the machine.
Use the speed adjustment button "+"
(4A) or "-" (4B) to adjust the speed
of the tool. Do not put the machine
down while the motor
is still running. Do not place the
machine on dusty surfaces. Dust
particles may enter the mechanism.
Too much load at low speed will
burn out the engine.
Note: after the tool stops working
for 15 seconds, the light will turn off
automatically.
Hold the tool correctly
ACTION FIGURE
See Fig. A
EN