Zephyr ARC Serie Guide D'utilisation, D'entretien Et D'installation page 20

COMPLETE THE
INSTALLATION
Model Incline
Re-install the mesh filters (see section "MESH
FILTERS").
Reassemble the front panel. See instructions
of Fig.8, proceeding in revers order.
Model Wave
Reassemble the metal panel and the lower
glass. See Fig. 10 and 9.
MESH FILTERS
NOTE: prior to use, remove protective film
from the filter frame.
DUCTED AND NON-DUCTED HOODS
Model Incline
1. To remove the upper MESH filter,
remove the front panel (Fig.31). Pull
down on latch tab to disengage the filter
from the hood. Tilt the filter downward
and remove.
To remove the lower MESH filter, pull
down on latch tab to disengage the filter
from the hood. Tilt the filter downward
and remove (Fig.32).
2. To install the MESH filter, align rear filter
tabs with slots in the hood. Pull latch tab
down. Push filter into place and release
tab. Make sure the filter is securely
engaged after installation.
Model Wave
1. To remove the MESH filters, open the
upper front glass (Fig.33). Pull down on
latch tab to disengage the filter from the
hood. Tilt the filter downward and
remove (Fig.33).
2. To install the MESH filter, align rear filter
tabs with slots in the hood. Pull latch tab
down. Push filter into place and release
tab. Make sure the filter is securely
engaged after installation.
NON-DUCTED HOODS ONLY
Model Incline
1. To remove the CHARCOAL filter, remove
the front panel and the mesh filter (Fig.31-
All manuals and user guides at all-guides.com
- 28 -
Model Incline
Upper mesh filter
FIG.31
Model Incline
Lower mesh filter
FIG.32
Model Wave
FIG.33