Zephyr ARC Serie Guide D'utilisation, D'entretien Et D'installation page 10

REMOTE BLOWERS (EXTERNAL AND IN-LINE)
CAUTION: To reduce risk of fire and electric shock, install this range hood only with External
Blower Model CBE-1000, and In-Line Blower Model PBN-1000A. Other blowers cannot be
substituited.
INSTALLING THE DUCTWORK: REMOTE BLOWER
NOTE: To reduce the risk of fire, use only metal ductwork.
1. Choose the location where the External Blower or In-Line Blower will be mounted. See
illustrations below for mounting location suggestions and restrictions.
2. A straight, short duct run using a minimum 8" round duct will allow the hood to perform
most efficiently.
3. Long duct runs, elbows and transitions will reduce the performance of the hood. Use as
few of them as possible. Larger ducting may be required for best performance with long
duct runs.
4. After the Exterior or In-Line Blower has been installed, connect round metal ductwork
and work back towards the hood location. Use duct tape to seal joints between ductwork
sections.
All manuals and user guides at all-guides.com
Roof Pitch w/
Flashing & Cap
in-line
blower
(blower
housing)
Roof Pitch w/
Flashing & Cap
in-line
blower
(blower
housing)
(blower
housing)
Attic or crawl space
(blower
housing)
Attic or
crawl
space
- 18 -