Worx WP733E X Serie Notice Originale page 14

working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
4. INTENDED USE
This product is intended for domestic lawn mowing.
5. OPERATION INSTRUCTION
NOTE: Read instruction handbook before
operation this machine.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the handle bar
14
Assembling the grass collection
bag
Fitting the grass collection bag to
the lawn mower
NOTE: Depress the grass
collection bag slightly to ensure
that it is completely installed.
Checking the battery charge
condition
NOTE: Fig. D1 only applies for the
battery pack with battery indicator
light.
Charging the battery pack
More details can be found in
charger's manual.
Fitting / removing battery
Insert the safety key before
installing the battery pack.
OPERATION
Starting & stopping
Cordless Lawn Mower
Adjusting the cutting height
Remove the battery pack. Flip the
mower over. Grip one wheel and
pull or push it forward. Make sure
to pull it forward far enough that it
is able to be move up/down in the
wheel bracket. With the wheel in its
most forward position, slide it up
or down into the desired position.
Repeat the above steps to all four
wheels. Make sure all four wheels
are in the same cutting height.
the motor stops before adjusting
height. The blades continue
to rotate after the machine is
switched off, a rotating blade can
cause injury. Do not touch rotating
blades.
Grass bag filling indicator
Empty status: flap floats (a)
FIGURE
Fully status: flap falls down (b)
See Fig.
A1-A4
Removing / emptying grass
collection bag
See Fig.
B1-B3
outlet before using. Never lift the
See Fig. C1,
safety flap when the lawn mower
C2
is being used without fitted grass
collection bag.
Storage
See Fig. D1
MOWING TIPS
NOTE: ALWAYS INSPECT AREA WHERE MOWER IS
TO BE USED AND REMOVE ALL STONES, STICKS,
See Fig. D2 WIRE, METAL AND OTHER DEBRIS WHICH MIGHT
BE THROWN BY THE ROTATING BLADE.
1. Mow across the face of slopes, never up-and-down.
Exercise extreme caution when changing direction
See Fig. E1, E2
on slopes. Do not mow excessively steep slopes.
Always maintain good footing.
2. Release bail handle to turn mower "OFF" when
crossing any graveled area (stones can be thrown
by the blade).
See Fig. F
3. Set mower at highest cutting height when mowing
in rough ground or in tall weeds. Removing too
much grass at one time can cause circuit breaker
to trip, which stops mower.
WARNING! Stop, release
Operating Bail and wait until
WARNING! Always check the
safety flap close the discharge
See Fig. G1,
G2
See Fig. H
See Fig. I
See Fig. J1, J2
EN