Dometic HB2325 Installation, Usage, Entretien page 40

Use
CAUTION!
If the burner does not turn on:
● turn the knob to the small flame position (Fig. 5 3, page 8);
● proceed with manual ignition;
● check that there is gas in the cylinder.
If the device does not work, close the gas inlet tap and contact your
dealer.
Manual ignition of the hob
If the electronic ignition does not work, the manual ignition is used as a substitute.
CAUTION!
Ignition must be done without any cookware or other object on the
burners.
To generate the flame, fully press down the control knob (Fig. 5 6, page 8)
h
and turn it to the large flame position (Fig. 5 2, page 8).
Simultaneously ignite the burner with a match or gas lighter.
h
h Once the flame has been generated, press the knob down for a few seconds so
that the flame remains lit.
CAUTION!
If the burner does not turn on:
● check that there is gas in the cylinder.
If the device does not work, close the gas inlet tap and contact your
dealer.
Regulating the hob flame
h To adjust the flame, turn the knob to the desired position (Fig. 5 6, page
8).
40
EN