Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT:
always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
3) HOT PLATE
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps "C" and
the burner heads "T" (see fig. 8) with lukewarm
soapy water.
Following this, all parts should be thoroughly
rinsed and dried. Never wash them while they are
still warm and never use abrasive powders.
Do not allow vinegar, coffee, milk, salted water,
lemon or tomato juice from remaining in contact
with the enamelled surfaces for long periods of
time.
WARNINGS:
comply with the following instructions, before
remounting the parts:
- check that burner head "T" (fig. 8) slots have
not become clogged by foreign bodies.
- Check that enamelled burner cap "C" (fig. 8)
have correctly positioned on the burner head.
It must be steady.
All manuals and user guides at all-guides.com
CLEANING
FIG. 8
25
- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
hot plate.
- Do not force the taps if they are difficult open
or close. Contact the technical assistance
service for repairs.
- Correctly preserve the plate after use by
treating it with special products, easily
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust.
- Don't use steam jets for the equipment
cleaning.
Publicité
