Publicité
Les langues disponibles
Les langues disponibles
7.8. INTRODUCTION TO THE OPERATING
MODES.
Description
When the UPS starts, the display screen of this mode is
displayed for a few seconds to boot the CPU and the system.
LCD display
Description
The UPS is off and there is no output voltage available,
but it is charging the batteries.
LCD display
Description
If the input voltage is within the UPS ranges, the UPS will
supply a stable sinusoidal AC voltage to the loads and will
charge the batteries.
LCD display
82
UPS start-up
Mode without output
AC mode
ECO mode
Description
If the input voltage is within the adjustment ranges and ECO
mode is activated, the UPS supplies the bypass output voltage
in ECO mode (energy saving).
LCD display
Set ECO
mode
Important: The system will not allow this mode to be enabled
if you have not previously transferred to Bypass.
CVCF mode
Description
When the input frequency is within range, the UPS can be set
to a constant output frequency of 50 or 60 Hz. The device will
continue to charge the batteries in this mode.
LCD display
Configure
in standby
mode
Important: The system will not allow this mode to be enabled
if you have not previously transferred to Bypass.
SALICRU
Publicité
