Publicité
Les langues disponibles
Les langues disponibles
Connecting
the refrigerator
to a water source
Warning
Tools required
Cold water supply
8
All manuals and user guides at all-guides.com
Water connection instruction guide
Read all directions carefully before you begin.
Connect to potable water supply only.
IMPORTANT
If operating the refrigerator before installing the water connection, turn icemaker
•
to the OFF position to prevent operation without water.
•
All installations must be in accordance with local plumbing code requirements.
Use copper tubing and check for leaks.
•
•
Install copper tubing only in areas where temperatures will remain above freezing.
•
It may take up to 24 hours for your icemaker to begin producing ice.
Standard screwdriver
7 / 16
-inch and
1 / 2
-inch open-end wrenches or two adjustable wrenches
-inch nut driver
1 / 4
1 / 4
-inch drill bit
Hand drill or electric drill (properly grounded)
NOTE
Your refrigerator dealer has a kit available with a 1/4-inch saddle-type shut-off valve,
•
a union, and copper tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a piercing-type or 3/16-inch
saddle valve which reduces water flow and clogs more easily.
The icemaker water valve contains a flow washer which is used as a water
pressure regulator.
The icemaker needs to be connected to a cold water line with water pressure
20 ~ 120 psi (lb/inch
2
)
Installation
Publicité
