Publicité
Les langues disponibles
Les langues disponibles
Connect the tubing to
the refrigerator
Turn the water on at
the shutoff valve
All manuals and user guides at all-guides.com
Before making the connection to the refrigerator, be sure the refrigerator
power cord is not plugged into the wall outlet.
If your refrigerator does not have a water filter, we recommend installing
•
one. If your water supply has sand or particles, that could clog the screen of
the refrigerator's water valve. Install the filter in the water line near the
refrigerator.
Tubing Clamp
"
1/4
Compression
Nut
Ferrule
(sleeve)
1. Remove the plastic flexible cap from the water valve.
2. Place the compression nut and ferrule (sleeve) onto the end of the tubing as
shown.
3. Insert the end of the copper tubing into the connection as far as possible. While
holding the tubing, tighten the fitting.
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of copper tubing behind the refrigerator so it does not vibrate
against the back of the refrigerator or against the wall. Push the refrigerator
back to the wall.
Start the lcemaker
Set the icemaker switch to the ON position The icemaker will not begin to
operate until it reaches its operating temperature of 15 °F (-9 °C). It will then
begin operation automatically.
10
Installation
"
1/4
Tubing
Refrigerator Connection
Publicité
