Publicité
Les langues disponibles
Les langues disponibles
Installation
Pass the
Pass the refrigerator laterally through the access
door as shown in the right figure.
refrigerator
Mount the freezer and refrigerator
compartment doors
Mount them in the reverse sequence of removal after they pass through the access
door.
Water supply installation
Before
Automatic icemaker operation needs water pressure of 21~121 psi (1.5~8.5
installation
kgf/cm
3 seconds.)
If water pressure does not reach the rating 21 psi (1.5 kgf/cm
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
Keep the total length of the feed water pipe tube within 26' (8 m). Be careful for the
tube to avoid being kinked. If the tube is 26' (8 m) or longer it may cause trouble in
water feed owing to the drain water pressure.
Install the water supply line where it will not be affected by heat.
Warning
Connect to potable water supply only.
Disposal of the
This appliance contains fluids (refrigerant and lubricant) and is made of parts and
old appliance
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste material
and can be reused after rework (recycling). For recycling, please contact the local
agency.
7
All manuals and user guides at all-guides.com
2
) (That is, an instant paper cup (6 oz. or 180 cc) will be fully filled within
Max
5
4
3
2
1
Min
1
FRZ
3
2
TEMP
TEMP
REF
4
Max
5
2
) or below, it is
Publicité
