Stihl FS 40 Notice D'emploi page 32

English
Definitions
1 Loop Handle.
For easy control of machine during
cutting work.
2 Carrying Eye.
The device to connect the trimmer
to the harness.
3 Momentary Stop Switch.
Switches the engine's ignition
system off and stops the running
engine.
4 Throttle Trigger Interlock.
Must be depressed before the
throttle trigger can be activated.
5 Throttle Trigger.
Controls the speed of the engine.
6 Carburetor Adjusting Screw.
For tuning carburetor.
7 Choke Lever.
Eases engine starting by enriching
mixture.
8 Air Filter Cover.
Covers the air filter element.
9 Cap with Spark Plug Boot.
Connects the spark plug to the
ignition wire.
10. Machine Support.
For resting machine on the ground.
11 Fuel Pump.
Provides additional fuel feed for a
cold start.
12 Fuel Filler Cap.
For closing the fuel tank.
30
All manuals and user guides at all-guides.com
13 Fuel Tank.
For fuel and oil mixture.
14 Starter Grip.
The grip of the pull starter, which is
the device to start the engine.
15 Muffler (with spark arresting
screen).
Attenuates exhaust noises and
diverts exhaust gases away from
operator.
16 Mowing Head.
The cutting attachment for different
purposes.
17 Line Limiting Blade.
Metal blade at the deflector in order
to keep the line of the mowing head
at the proper length.
18 Deflector (for mowing heads).
The deflector is designed to reduce
the risk of injury from foreign objects
flung backwards toward the
operator by the cutting attachment
and from contact with the cutting
attachment.
19 Drive Tube.
Device to connect the engine with
the gearbox.
Specifications
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
Engine
Single cylinder two-stroke engine
FS 40, FS 40 C
Displacement: 27.2 cm
Bore: 34 mm
Stroke: 30 mm
Engine power to 0.7 kW at
ISO 8893: 8,500 rpm
Idle speed: 2,800 rpm
Cut-off speed (rated): 10,000 rpm
Max. output shaft
speed (cutting tool): 8,900 rpm
FS 40, FS 40 C, FS 50, FS 50 C
3