Télécharger Imprimer la page

Stihl FS 40 Notice D'emploi page 15

Masquer les pouces Voir aussi pour FS 40:

Publicité

Les langues disponibles

Les langues disponibles

Blocking the shaft
N
To block the shaft, insert a suitable
tool (12) through the holes (13) in
the deflector and thrust plate – turn
the thrust plate back and forth if
necessary.
FS 40, FS 40 C, FS 50, FS 50 C
All manuals and user guides at all-guides.com
STIHL FixCut 5-2
N
Slip the thrust plate (2) over the
shaft.
N
Place the mowing head on the
thrust plate (2).
Collar (see arrow) must engage
the mowing head's mounting hole.
N
Push the thrust washer (3) over the
shaft (1) so it is seated on the base.
N
Block the shaft – see "Blocking the
Shaft".
N
Use the combination wrench (5)
(special accessory) to screw the
mounting nut (4) on to the output
shaft clockwise and tighten it down
firmly.
Remove the locking pin.
Removing the mowing head
STIHL AutoCut
N
5
N
STIHL PolyCut
N
4
N
3
STIHL FixCut
N
1
2
N
Hold the mowing head steady.
Unscrew the cap counterclockwise.
Block the shaft – see "Blocking the
Shaft".
Unscrew the mowing head
counterclockwise.
Block the shaft – see "Blocking the
Shaft".
Use the combination wrench
(special accessory) to loosen and
unscrew the mounting nut
counterclockwise from the output
shaft.
If the mounting nut turns too
freely, fit a new one.
English
13

Publicité

loading

Ce manuel est également adapté pour:

Fs 50