Publicité
Les langues disponibles
Les langues disponibles
3. Install the Bath
Construction Adhesive
Mortar Cement
Construction Adhesive
NOTE: Some models come with support blocks. Some models have molded supports.
Apply a generous amount of construction adhesive to the bath feet or base.
Lift the bath into place.
Verify that the bath is level and the feet or base are supported.
Apply weight evenly to the bath basin until the adhesive sets.
Mortar Cement
NOTE: Do not use gypsum cement or drywall compound for this application, as they will not provide an acceptable,
durable bond.
NOTE: Lay plastic film on wooden subfloors if desired to prevent water absorption.
Set the bath area in 1" (25 mm) to 2" (51 mm) of mortar cement.
Verify that the bath is level and the feet or base are supported.
Apply weight evenly to the bath basin until the adhesive sets.
1499222-2-A
6
Kohler Co.
Publicité
