Publicité
Les langues disponibles
Les langues disponibles
Tracks programming (by remote control)
Up to 10 tracks can be programmed for MP3 file and play in any order. Before use, be sure the system
is at stop mode before programming:
1. Set in USB mode & set at stop mode.
2. Press the "Program" button, " Prog " will appear on LCD display (2). Moreover, it will indicate
program no. and digits for track no. to be programmed.
3. Select a desired track by pressing Skip up
4. Press the " Program " button to store the trace into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press " Play/Pause/Stop "
to play the disc in assigned order.
7. To cancel the programmed file, stop playback the unit and then press "Program" button on remote
handset until " Prog " is disappear on LCD display (2).
Encoding of Phono into MP3 file
The system is able to encode the phono to MP3 format and recording at memory media with USB
connecting port.
A) Phono/Aux encoding
1) Insert the USB to the main unit refer the Playback of MP3 song via USB storage media or memory
card section.
2) Set the function button to " Phono/Aux " mode and then press the "
3) The LCD display will show "
mode after few seconds,.
4) Start playback at phono for the track which you want to record to USB or start to playback your
external device from Aux in(connection detail please refer the "Aux in connection" part at below
page of this manual).
5) After finish of recoding, press the " Rec " button (3) until the LCD stop flashing and return to "
phono " mode.
Remark:
-
The recording speed is 1:1 and according to the actual plying time of the phono
-
The system will create a folder and then store the encoding track in it.
-
The recording format is set at – MP3 bit rate : 128 kbps, sampling rate : 44.1kHz
-
No song title will be recorded during encoding mode.
B) Track separation (by remote handset)
You can divide the recording music from phono to USB track by track during encoding. Every time
when press the "
" (track separation) button once at remote handset during encoding from pho-
no to USB, the system will generate a new track and continuous the recording. The text " phono " at
LCD display will flashing one time, it mean the unit is creating a new track successfully.
Removing of USB
To remove the USB, turn off the power or switch the function mode to tuner first. For USB port – un-
plug it by pulling out the USB socket directly.
Phono noted:
-
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before operating and
re-secured again afterwards.
All manuals and user guides at all-guides.com
(20) or down
" & "
" and flashing, and the system is starting the encoding
buttons (12).
button (13)
Rec " button (3) directly.
14
Publicité
