Askoll PURE M LED Manuel D'instructions page 7

3.3. Technical data
Description
Capacity
Product weight
Max. weight with water
Height
Width
Depth
Water temperature
(min. / max.)
PUMP / LIgHTINg UNIT / THERMAL HEATER
Power supply
Consumption
IP protection rating
4. PREPARINg ThE PROduCT FOR uSE
4.1. unpacking
WARNING
The product has glass components.
Handle with care and place it according to the instruc-
tions of this manual avoiding to lean the tank directly
on the edges.
1) Open the carton's top flaps and remove the polystyrene sheet.
2) Extract the product as indicated on the packaging itself. Always
handle it with care.
3) Place it on a flat, smooth and clean surface; take care not to
scratch or damage the glass tank bottom.
4) Remove the transparent film on the covers and upper frame.
5) Remove the lighting and filter covers from the frame (fig. 3) and
place them on a flat, clean surface without scratching them.
6) Remove the pump unit (fig. 4) and place it on a flat surface.
7) Remove the frame from the tank (fig. 5) and place it on a flat,
clean surface without scratching it.
3
All manuals and user guides at all-guides.com
PURE PURE PURE
M LED L LED XL LED
L 44 68
Imp gal 9.68 14.96 20.68
kg 8.8 14.1 19.2
kg 70 105 150
cm 43.5 43.5 43.5
cm 36 56
cm 36 36
°C from +5 to +35
V / Hz
See data provided on the
W
individual electric devices
making up the product.
4
EN
8) Carefully remove the thermal heater and led driver from their
packaging inside the tank, along with the cable guide.
9) Dispose of the packaging material in observance of local reg-
ulations.
10) Check that the product has all the components indicated in par.
94
3.2.
4.2. Positioning
The product must be positioned with care, in observance of the fol-
lowing instructions:
76
36
To avoid instability risk: check with a level that the sup-
port surface of the product is horizontal.
Do not lean the product on inclined surfaces.
It is advisable to place the product on the foreseen
aquarium stand. Alternatively, use a sturdy support
able to bear the maximum weight set for the product
(see technical data par. 3.3). Such support must have
a levelled, smooth and clean support surface.
In order not to ease algae proliferation: place the
product far from heat sources and direct exposure to
sunlight.
1) Position the product so that the wording "FRONT" is at the front
and at a distance from the power outlet which enables each
electrical equipment cable to have a drip loop.
2) Remove the "FRONT" label and dispose of it as required by local
regulations.
WARNING
CAUTION
5
7