Homelite EL16B Manuel De L'utilisateur page 11

OPERATING CHAIN
SAW
Continued
Log Supported On Both Ends
1. Make first cut from above log (see Fig-
ure 16). Cut 1/3 through diameter of
log. This cut will keep section from
splintering when cut.
2. Make second cut on underside of log,
directly under first cut. Use top of guide
bar to make this cut. Cut up to meet
first cut. This will keep log from pinch-
ing guide bar and chain.
2nd Cut
Figure 16 - Bucking Log When Log Is
Supported On Both Ends
101473
All manuals and user guides at all-guides.com
TRIMMING A TREE (Pruning)
WARNING: Avoid kickback.
Kickback can result in severe in-
jury or death. See Kickback , page
3, to avoid risk of kickback.
WARNING: Do not operate
chain saw while
• in a tree
• on a ladder or any other un-
stable surface
• in any awkward position
You may lose control of saw caus-
ing severe injury.
1st Cut
WARNING: Do not cut limbs
higher than your shoulders.
CAUTION: Seek professional
help if facing conditions beyond
your ability.
Figure 17 - Cutting A Limb
OWNER'S MANUAL
Trimming a tree is the process of cutting
limbs from a living tree. Make sure your
footing is firm. Keep feet apart. Divide your
weight evenly on both feet. Follow direc-
tions below to trim a tree.
1. Make first cut 15 centimeters (six
2. Move five to ten centimeters (two to
3. Make third cut as close to tree trunk as
4. Make fourth cut directly above third
4th Cut - Final
Stub Cut
15 cm
(6")
1st Cut - Pruning
Undercut
(to avoid splintering)
3rd Cut - Stub Undercut
(to avoid splintering)
11
inches) from tree trunk on underside of
limb. Use top of guide bar to make this
cut. Cut 1/3 through diameter of limb
(see Figure 17).
four inches) farther out on limb. Make
second cut from above limb. Continue
cut until you cut limb off.
possible on underside of limb stub. Use
top of guide bar to make this cut. Cut
1/3 through diameter of stub.
cut. Cut down to meet third cut. This
will remove limb stub.
2nd Cut - Pruning Cut
(to avoid pinching)
5 to 10 cm
(2" to 4")