Publicité
Les langues disponibles
Les langues disponibles
In this screen you can check the navigation connections. The Reverse (REV) and
Speed-pulse (SPD) connections are necessary for accurate calibration and
functionality.
Menu
1
Select
(Vehicle Signal).
REV. : With the reverse signal wire connected and with
reverse gear selected, the REV indicator will
change to 'ON'. The current position cursor will
move backwards on the map screen (while the
vehicle is reversing).
PKB. : By applying the handbrake, the destination input is activated.
ILL. : The illumination connection makes it possible to change the map screen
automatically between day and night mode.
SPD. : The speed-pulse is collected from the vehicles electronics and is necessary to
tell the navigation system how fast the car is moving. This speed is an
approximation and may differ from that shown on the vehicles speedometer.
GPS : The number of received GPS satellites is shown and the current position,
expressed in Latitude and Longitude.
This function allows you to correct any error in the position or direction of your
vehicle display.
Position
Position
Menu
1
Select
(Calibration).
2
Select
Position
3
Move the
to the correct position and select
OK
.
4
Use
or
direction in which you are driving, and select
.
OK
Vehicle Signal
(Navigation Set Up)
Calibration
(Navigation Set Up)
.
to make
point in the
31
Publicité
