Konect PROX4 Manuel D'utilisation page 24

INC
DEC
Product version
Product Version
V1.1.1
DEC INC
Firmware Upgrade
- >
INC
DEC
Power Mode
Dynamic Mode
13. WARNING AND ERROR MESSAGES
It will show the Error information with a beep sound when operation error.
1. {« BATTERY CONNECT ERROR »}
Interruption of battery and output end, or the
charger wire has not been connected well when
charging or discharging
2. {« INPUT VOLTAGE FLUCTUATION »}
Input voltage fluctuation range over 1V, please
check input power to ensure input voltage
fluctuation range not exceeds the normal
allowable range.
3.{ « BATTERY VOL ERR CELL CONNECT »}
unit battery voltage error, please check the
battery voltage one by one.
4. {« TEMP OVER ERR »}
The internal temperature of the unit goes too
high, you need to cooling down the unit
24
Product version
This is used to check product version
This is used to check product version
Firmware upgrade
Firmware upgrade
Press ENTER key to do firmware upgrade
Press ENTER key to do rmware upgrade
Power Allocation
Power Allocation
Under AC power supply, you can choose the power allocation mode,
Under AC power supply, you can choose the power
intelligent allocation or average allocation.
allocation mode, intelligent allocation or average
First priority: intelligent allocation.
allocation.
Dynamic Mode: average allocation.
First priority: intelligent allocation.
Dynamic Mode: average allocation.
5. {« SHORT CIRCUIT ERROR »}
Short circuit, you need to check charge circuit
and related equipment.
6. {« CAP OUT »}
Over the charger's capacity protection set
value, you need to check and reset the capacity
protection value.
7. {« INPUT VOLTAGE ERROR »}
Input voltage error, you need to check the input
power to make sure the input power correct.
8. {« REVERSE PLOARITY »}
Battery output polarity connection wrong, you
need to reverse connected battery polarity.
9. {« SAFETY TIME OUT! »}
You need to reset the safety charge time.