Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting Tips... Before you call for service
Save time and money! Review the charts on the following pages first and you may not need to call for service.
Problem
Zoneline does not start.
Zoneline does not cool or
heat as it should.
Burning odor at the start
of heating operation.
The air is not always cool
or hot during operation.
The air does not feel warm
enough during heating
operation
The unit is not blowing
out air
The electric heating and
fan features do not work
Possible Cause
The direct connect kit is not firmly
attached.
The fuse is blown/circuit breaker
is tripped.
The unit is waiting for the
compressor overload protector to
reset.
Power Failure.
Indoor airflow is restricted.
Outdoor airflow is restricted or
recirculated.
The thermostat control may not be
set properly.
The air filter is dirty.
The room may have been hot or
cold.
Dust on the surface of the heating
elements.
The heat pump is not producing
hot air.
The Zoneline unit's fan is
continuously running, even during
the OFF cycle.
The heat pump alone produces air
that feels cooler than desired.
The external wall thermostat's
"fan" setting may be set to "auto"
The personality jumper is not
firmly attached.
What To Do
black connector on the end of the power cord is firmly
engaged.
Check the house fuse/circuit breaker box and replace
the fuse or reset the breaker.
resets.
prevent tripping of the compressor overload. For this
reason, the unit may not start normal heating or cooling
for 3 minutes after it is turned back on.
Make sure there are no curtains, blinds or furniture
blocking the air discharge grille or the return air grille.
cause the unit to cycle off due to the compressor
overload protector.
free area. Non-GE Appliances louvers may be too
restrictive for proper performance. Consult your
salesperson for assistance.
NOTE:
temperature range.
and Cleaning section
time for the room to cool down or warm up.
but not as hot as air produced when the higher-cost
electric heat is used.
continuous air movement provides better overall
cooling the room, set the external wall thermostat's fan
-OR-
NOTE: Use of this option will result in increased energy
consumption.
actively heating or cooling the room, set the external
black connector on the end of the power cord is firmly
engaged.
49-5000640 Rev. 1
Publicité
