ASSEMBLY
(FOR 40, 55T, AND 70T MODELS ONLY)
These models are furnished with a nose cone
guard. Nose cone guard and mounting screws are
found in the shipping carton.
Tools Needed
• 5/16" Nut Driver or Wrench
1. Place nose cone guard on top of upper shell
flange. Make sure nose cone guard is on hot
air outlet end of heater.
2. Insert screws through nose cone guard and
upper shell flange.
3. Tighten screws firmly.
Screw
Hot Air
Outlet
Upper Shell
Flange
Figure 4 - Nose Cone Guard Assembly,
40/55T/70T Models Only
4
Nose Cone
Guard
www.desatech.com
111168-01A