Hilti DCH 300 Mode D'emploi Original page 28

▶ Guide the power tool smoothly and do not apply lateral pressure to the cutting disc. Always bring the
power tool into contact with the workpiece at right angles. Do not attempt to change the line of cut by
applying lateral pressure or by bending the cutting disc while cutting is in progress. This could damage
the cutting disc and cause it to break.
▶ Never use the power tool without the guard.
3 Description
3.1 Product overview
DCH 300
3.2 Product overview
DCH 300–X
22 English
1
2
Cut indicator
@
Dust removal connector cap
;
Guard
=
Rear grip
%
Switch-on interlock
&
On/off switch
(
Service indicator
)
Diamond cut-off wheel
+
Front grip
§
Guide roller
/
Arbor lockbutton
:
Hood clamping screw
∙
Clamping nut wrench, 24 / 10 mm AF
$
Hex key, 6 mm AF
£
2149874
*2149874*