Throttle Lockout; Reduction Gearbox; Anti-Vibration System; Procedures To Be Performed After Every 100 Hours Of Use - Husqvarna 226HD60S Manuel D'utilisation

English

THROTTLE LOCKOUT

• Stop operation if the throttle lockout is defective.
• The throttle lockout is the device not to accelerate the
throttle lever without intention. While pushing the
throttle lockout, you can accelerate the throttle lever.
(1)
1. Check if the throttle lever does not move when you do
not push the throttle lockout.
2. Check if the throttle lever moves when you grasp or
release it while pushing the throttle lockout.
3. Check if the throttle lockout returns to its original
position when you release your hand from the throttle
lockout.
• If you find any defects at the checks above, contact your
nearest servicing dealer for repair.

REDUCTION GEARBOX

Refill gear housing every 50 working hours. Use
Husqvarna's special grease.
Use the grease pump. Feed grease until it comes out of
the base of the blades.
• Grease nipple : A type

ANTI-VIBRATION SYSTEM

A deformed or damaged anti-vibration system may
cause breakages like getting rickety or falling off of
engine and/or blade
• Check that the vibration damping elements are not
damaged.
16
Maintenance
(1) Throttle lockout
PROCEDURES TO BE PERFORMED
AFTER EVERY 100 HOURS OF USE
1. Tighten all screws, bolts, and fittings.
2. Check to see if any oil or grease has worked its way in
between the clutch lining and drum, and if it has wipe it
away using oil-free, lead-free gasoline.
3. Remove the muffler, insert a screwdriver into the vent,
and wipe away any carbon buildup. Wipe away any
carbon buildup on the muffler exhaust vent and cylinder
exhaust port at the same time.

MUFFLER

WARNING
• Inspect periodically, the muffler for loose fasteners, any
damage or corrosion. If any sign of exhaust leakage
is found, stop using the machine and have it repaired
immediately.
• Note that failing to do so may result in the engine
catching on fire.
IMPORTANT
• Before starting operation, always make sure to check if
the muffler is properly held by three bolts. (Fastening
Torque : 8 to 12 N·m)
• Also make sure that the speak arrester and the diffuser
are properly attached with four bolts. (Fastening Torque :
2 to 3 N·m)
• Even if one of seven bolts is loose, it may result in engine
catching on fire.

SPARK ARRESTER

• The muffler is equipped with a spark arrester to prevent
red hot carbon from flying out of the exhaust outlet.
Periodically inspect and clean as necessary with a wire
brush. In the State of California it is required by law
(Section 4442 of the California Pulic Resources Code) to
equip a spark arrester when a gas powered tool is used
in any forest covered, bush covered, or grass covered
unimproved land.
(1)
(2)
(1) Bolt
(2) Spark arrester