Publicité
Les langues disponibles
Les langues disponibles
Operation
The LCD displaying fully for 3 seconds then into RF signal searching for 2 minutes when
-
changing a new battery or resetting. It will automatically exit then into normal display.
-
Press SET/°C/°F once to select the °C and °F in normal mode.
Press MAX/MIN/+ once to check the memory of the indoor/outdoor temperature in normal mode.
-
Press MAX/MIN/+ for two seconds to clear the memory value when in temperature memory value
-
displaying.
It will automatically clear the indoor/outdoor temperature memory values at 0:00 everyday.
-
-
Press SET/°C/°F more than 2 seconds to time setting then to adjust by pressing MAX/MIN
Please change a new battery When "
-
The signal is very good when "
-
" "
When there is no signal for one hour it will automatically search the signal again for two
-
minutes.
Time setting
1.
Hold the SET/°C/°F button for 2 seconds to enter time setting and 24 Hr is blinking.
2.
Press the MAX/MIN/+ button to select 12 Hr or 24 Hr time display. Press the SET/°C/°F button to
confirm your setting and continue.
3.
The hour numbers are blinking. Press the MAX/MIN/+ button to set the hours. Press the SET/°C/°F
button to confirm your setting and continue.
4.
The minute numbers are blinking. Press the MAX/MIN/+ button to set the minutes. Press the
SET/°C/°F button to confirm your setting and return to normal time display.
Note: Hold the MAX/MIN/+ button to accelerate the setting of values.
Specification
-
Input voltage: 2.6V-3.3V
Indoor temperature scope: 0°C ～ 50°C / 32°F ～ 122°F
-
Outdoor temperature scope: -40°C ～ 70°C/ -40°F ～ 158°F
-
-
Temperature resolution: 0.1C° / 0.1°F
"displaying.
" displaying. When signal is bad it will display
Publicité
