Maintenance Schedule - Husqvarna 536LiP4 Manuel D'utilisation

Maintenance schedule

Li-ion Li-ion
WARNING! Always disconnect the
!
battery before any maintenace on the
machine.
The following is a list of the maintenance that must be performed on the machine. Most of the items are described in the
Maintenance section.
Maintenance
Clean the outside of the machine with a clean and dry cloth.
Never use water.
Keep handles dry, clean and free from oil and grease.
Make sure that the activate and deactivate button works correctly
and is not damaged.
Check that all controls are undamaged and in working order.
Make sure that the power trigger lock and the power trigger
function works correctly from a safety point of view.
Ensure that the chip guard is not damaged and is not cracked.
Replace the guard if it has been exposed to impact or is cracked.
Check that nuts and screws are tight.
Check that the battery is intact.
Check the battery's charge.
Check that the release buttons on the battery works and locks the
battery into the machine.
Check that the battery charger is intact and functional.
Clean the oil tank vent
Check that all couplings, connections and cables are intact and
free from dirt.
Clean the chip guard
Check the connections between the battery and the machine and
also check the connection between battery and the battery
charger.
Check that the saw head is not damaged. Replace the saw head
if it is damaged.
Check condition of Drive Sprocket.
28 – English
MAINTENANCE
Daily
Maintenance
All service on the saw head must be carried out by
Change the chain sprocket after approx. 100 hours
Weekly
maintenance
X
X
X
X
X
X
X
X
X
X
X
X
X
X
an authorized Husqvarna dealer.
of use or if there is significant play on the shaft.
Monthly
maintenance
X