When the charger is connected to the vehicle, the tap card area four corners will light up,
indicating that the charger can read the RFID card to start operating.
Hold the RFID card close to the tap area for a few seconds, trying to stay as close as possible to
the tap area.
When a single sound is heard and the LED belt light changes from steady blue to blinking blue,
the charger is ready and starts charging the EV battery.
The plug cannot be disconnected when the charging process is running.
To stop the charging process, hold the RFID card close to the tap area again. A sound is produced
by the charger indicating that the charge process has been stopped. The connector can be
unplugged.
Warning: if two sounds (whose interval is about 0.5 sec.) are produced instead of a
single one, it means the RFID card is not working properly and somehow failed to trigger the
process.
Warning: for the CASE B mode (without the integrated cable), there is an electronic lock
inside the charger to keep the electrical connection stable during the charging process. When
charging is completed or a fault occurs, the electronic lock will automatically unlock, please do
not pull it forcibly otherwise.
Markings
Cabur S.r.L. – Località Isola Grande 45 17041 Altare SV Italy
Point of contact under Directive 2014/35/EU:
9