ETI EV PLUS Serie Manuel D'installation page 39

8.1.3 WiFi CLIENT mode
When in CLIENT mode, the charger can be connected to an available WiFi network. The charger
control can be achieved by a server which supports the OCPP protocol.
The current series of ETI`s chargers supports the OCPP 1.6 J version of the protocol.
To configure the WiFi interface of the charger in CLIENT mode the user should perform the
following steps.
Important note: before switching to CLIENT mode all the needed configurations must
be completed in AP mode.
Step Description
No.
1 Open the black front panel, just sliding the two locks in
the charger backside
2 Press the button highlighted in the following picture for
more than 3 sec. continuously
3 Wait for the sound (1 sec. duration) from the charge,
which says the change of WiFi mode has been
completed
4 The WiFi indicator will change its colour from blue to
green
5 Close the black front panel of the charger.
February 2023
Picture
37