Mettler Toledo PANTHER Guide D'installation page 20

METTLER TOLEDO PANTHER/PANTHER PLUS Terminals Installation Guide
If an analog version of the PANTHER
panel-mount terminal is used in a
hazardous area classified as Division 2
or Zone 2/22, or if only the load cells
will be in a hazardous area classified as
Division 2 or Zone 2/22, METTLER
TOLEDO control drawing 155907R
must be followed for Division 2 Areas.
Refer to the Division 2 guide at the end
of this manual. Refer to the Panther
European Category 3 G/D Installation
Manual, (*)16684500A, for Zone 2/22
area installation.
2-2 (7/03)
Connect to TB3 of the terminal's Controller PCB.
Standard 6-wire Cable
1.
TB3
Figure 10: Wiring for PTHN/PTHK
Standard 6-wire Cable
TB3
Standard 4-wire Cable
Figure 11: Wiring for PTPN
TB3
Standard 4-wire Cable
TB3