Mettler Toledo PANTHER Guide D'installation page 193

If a signal cannot be classified as non-incendive, follow the electrical regulations for the
country of installation for specific wiring requirements of incendive equipment in a Division 2
area.
TO USE THE ANALOG PANTHER PANEL-MOUNT TERMINAL IN AN AREA
CLASSIFIED AS CLASS I, II OR III, DIVISION 2, GROUPS A, B, C, D, F OR G,
METTLER TOLEDO CONTROL DRAWING 155907R MUST BE FOLLOWED
WITHOUT EXCEPTION. FAILURE TO DO SO COULD RESULT IN BODILY HARM
AND/OR PROPERTY DAMAGE.
Chapter 1: Introduction
Protection Approaches
WARNING
(7/03) 1-3