Mettler Toledo PANTHER Guide D'installation page 186

PRECAUTIONS
READ this manual BEFORE
installing, operating or servicing
this equipment.
FOLLOW these guidelines
carefully.
SAVE this manual for future
reference.
DO NOT allow untrained
personnel to operate, clean,
inspect, maintain, service, or
tamper with this equipment.
ALWAYS DISCONNECT this
equipment from the power
source before cleaning or
performing maintenance.
CALL METTLER TOLEDO for parts,
information, and service.
METTLER TOLEDO ASSUMES NO RESPONSIBILITY FOR CORRECT
INSTALLATION OF THIS EQUIPMENT WITHIN A DIVISION 2 AREA.
THE INSTALLER MUST BE FAMILIAR WITH ALL DIVISION 2 WIRING
AND INSTALLATION REQUIREMENTS.
THE PANTHER PANEL-MOUNT TERMINAL IS NOT INTRINSICALLY
SAFE! DO NOT USE WITHIN AREAS CLASSIFIED AS HAZARDOUS
DIVISION 1 OR ZONE 0/1 BECAUSE OF COMBUSTIBLE OR EXPLOSIVE
ATMOSPHERES.
DISCONNECT ALL POWER TO THIS UNIT BEFORE INSTALLING,
SERVICING, CLEANING, OR REMOVING THE FUSE. FAILURE TO DO SO
COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
THE PANTHER PANEL-MOUNT TERMINAL HAS A TEMPERATURE
°
RATING OF T4a (120 C). IT MUST NOT BE USED IN AREAS WHERE
THE AUTO IGNITION TEMPERATURE OF THE HAZARDOUS MATERIAL
IS BELOW THIS RATING.
PREVIOUS MODELS OF THE PANTHER PANEL-MOUNT TERMINAL
WHICH ARE NOT FACTORY-LABELED FOR DIVISION 2 COMPLIANCE
MAY NOT BE INSTALLED INTO A DIVISION 2 ENVIRONMENT. THE
PANTHER HARSH ENVIRONMENT TEMRINAL IS NOT APPROVED FOR
USE IN AREAS CLASSIFIED AS DIVISION 2.
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC
SENSITIVE DEVICES.
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
CAUTION