Ptpn - Mettler Toledo PANTHER Guide D'installation

METTLER TOLEDO PANTHER/PANTHER PLUS Terminals Installation Guide

PTPN

Figure 8: Analog PCB
1-8 (7/03)
Access to the PANTHER panel-mount model is at the back of the terminal where all
connections are made to the terminal strips on the controller PCB (Figure 7 shows the
back of both the DigiTOL and analog versions which are identical although TB3 will be
labeled differently.)
If access inside the unit is necessary, remove the two screws holding the cover plate at
the rear of the unit and lift the cover plate over the terminal strips. Doing so will reveal
the entire Controller PCB. See Figures 8 and 9.
TB1 TB2 TB3
Figure 7: Back of PTPN
Figure 9: DigiTOL PCB