Technical Data - Solarc e.GO! MASTER Manuel D'utilisation Et Informations Techniques

Additional module
with cable adapter
Possible combinations for the solar operation of e.
Connecting 1 or 2 solar modules with base unit via hinge (delivering condition)
Connecting an optional additional module with base unit via cable adapter and DC input socket
Connecting 1 or 2 solar modules via hinge with base device + additional module via cable adapter and DC input socket with base unit. E.g.
additional module fastening with straps by slits in the cable adapter on the backpack, putting base unit in the backpack or in the shade.

7. Technical data

Nominal power solar modules:: 1,1 W (FUN), 2,2 W (MASTER), 2,6 W (PROFESSIONAL)
Output power for operation of an external device : 1.3 / 2.5 / 4.0 W (at 5 ... 10 V output voltage and 25°C)
Output voltage range: 4 ... 14 V (depending on adapter cable)
Input voltage / current DC input socket: 4.5 ... 5.5 V/ max. 1.8 A
Charging current internal batteries: max. 1 a per battery or battery string
Closed-circuit current in stand-by mode: 0.8 mA (with 2 AA batteries)
Voltage range mains adapter: 90 ... 270 V AC, mains plug Europe norm
Ambient temperature range: 0 ... +45°C (storage), -20 ... +50°C(discharge and storage), +10 ... +30°C (recommended operating range)
Max. rel. humidity: 95%
Safety class: IP52
Case materials: PC-ABS, PMMA, Santoprene
Dimensions: 160 x 90 x 36 mm
Weight: 300 g without batteries
8. What to do at problems
Table3: Problems and possible remedy
Symptom
Batteries also after several hours not charged
despite attached mains adapter
Batteries also after several hours not charged
despite an illuminated solar module
No LED shines despite attached mains adapter or
illuminated solar module and/or attached external
device and/or battery charged inserted
Attached terminal cannot be charged or operated No charged batteries in e.
GO!
Note: At abnormal function of e. first remove all power sources (batteries, mains adapter) and fold solar modules, wait at least 10 seconds, then reconnect e.
function then, go on as described above.
GO!
:
Possible causes
Battery contacts soiled
Batteries or electronics faulty
Battery contacts soiled
Hinge contacts soiled
Solar module or electronics faulty
Max. temperature range exceeded
Battery contacts soiled
Electronics faulty
GO!
inserted and solar module not
in full sunlight
Contact fault to socket DC output or mobile phone plug
Cable or electronics faulty
13
Remedy
Cleaning battery contacts with contact spray or the like
Exchanging batteries or sending in device for the repair
Cleaning battery contacts with contact spray or the like
Cleaning hinge pins with contact spray or the like
Exchanging batteries or sending in device for the repair
Having to cool down or to heat up
Cleaning battery contacts with contact spray or the like
Sending in device for the repair
Inserting charged batteries or lining up in sunlight full of solar module, if
necessary switch on step 1
Multiple one and end stick of the plug in question, test with another cable
otherwise
Sending in cables and device for the repair
GO!
. If there is no normal