Solarc e.GO! MASTER Manuel D'utilisation Et Informations Techniques page 12

Chargeur de piles rechargeables universel
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PROFESSIONAL
With Li-Ionen batteries (only
No different charge modes, generally max. 1 A of charging current, very exact charge condition display LED1-3 (deviation < 20%).
Trickle charge:
After a complete charging of the internal batteries transition into trickle charge (pulse charge): LED5 flashes during charging.
Stand-by (with inserted batterie):
Current saving operation (stand-by mode) without adapter cable plugged in and without mains adapter. At connection of mains adapter or adapter cable
transition into active mode (LED display see Tab. 2).
Without inserted batteries (direct operation):
Direct operation of an external device by solar modules or by a current source at the DC input (mains adapter, additional solar module etc.) via adapter
cable, if no batteries are inserted. For pure solar operation output power dependent on solar radiation!
Recommendation for solar operation or charge of external devices with maximum efficiency:
GO!
Battery charged (ideal: Li-Ion) in e.
Table1: Battery types and charge times
Battery type, max. permitted
charging current
NiMH AA, 1A
NiCd AA, 1A
NiMH AAA (via adapters), 1A
RAM AA, 1A**
Li-Ionen, e. g. Panasonic CGA E/101
or Fuji NP-120
* with 2 batteries AA or 1 battery Li-ion (only PROFESSIONAL), solar at full sun 1000 W/m2 and 10 -30°C T
** only usable under limited conditions, see Kap 8
Table2: Charge condition display LED 1-3
Battery-charging up condition
LED1
0%
--
< 20%
flash
20 ... < 50%
--
50 ... < 80%
--
80 ... 100%
flash
/ combine / remove solar modules
6. Install
First pull out intermediate part (hinge safeguard) until the stop as shown - possibly with a screwdriver -, then remove lid solar module at the side, then
remove base solar module at the side in the other direction.
):
and at full sun in switch position 1 (1.3 W) or with additional double module in switch position 1 or 2 (2.5 W).
Typical capacity
Charge time with mains
adapter*
1000 - 2400 mAh
1,5 – 5 hrs.
500 - 1000 mAh
1 – 2 hrs.
600 - 1000 mAh
1 – 2 hrs.
1500 - 2000 mAh
4 - 8 hrs.
1700 mAh
2,5 hrs.
Stand-by (flashes slowly)
LED2
LED3
--
--
--
--
flash
--
--
flash
flash
flash
12
Charge time solar*
Charge time solar*
(PROFESSIONAL,
MASTER)
2 – 6 hrs..
1 – 2,5 hrs.
1 – 2,5 hrs.
4 - 8 hrs.
4 hrs.
. Approximately doubled charge time with 4 batteries.
ambient
Aktive operation (flashes fast)
LED1
LED2
LED3
--
--
--
flash
--
--
flash
flash
--
flash
flash
flash
flash
flash
flash
(FUN)
4 – 12 hrs.
2 – 5 hrs.
2 – 5 hrs.
8 - 12 hrs.
--

Publicité

Table des Matières
loading

Produits Connexes pour Solarc e.GO! MASTER

Ce manuel est également adapté pour:

E.go! funE.go! professional502750355036

Table des Matières